Green, blinking once every 2s: The USB Stick is registered with a 2G network. Green, blinking twice every 2s: The USB Stick is powered on. IndicatorIt indicates the status of the USB Stick USB Connectorit connects the USB Stick to a pc2. Getting to Know Your USB StickThe following figure shows the appearance of the USB Stick. Hardware system should meet the recommended reqirements for the installed OS version. Windows 7, Windows 8, Windows 8.1, Windows10, (Does not support Windows RT). Where eth1 should be replaced with the modem’s device name.MTN Fastlink E303 HSPA USB Stick modem is a superfast USB Modem that you plug to your Personal Computer or Laptop and start enjoying very fast internet service at your office or at your home.MTN FastLink E303 HSPA USB Modem 7.2Mbps maximum downlink Works with MTN,Airtel, Glo & Etisalat Comes with MicroSD Slot (Can be used as flash drive) SMS Capable Phonebook functionality Compatible with Windows 7/8/8.1/10 (Does not support Windows RT) Plug & Play (No CD Driver required) Enjoy the best of internet access on your PC and start browsing Immediately! High Speed.It works with ONLY 3G networks of MTN, Glo, 9Mobile and Airtel in Nigeria. In Debian-based distributions, add the following lines at the end of the file /etc/network/interfaces : allow-hotplug eth1 
To automatically enable the modem whenever it’s plugged in and across restarts, you’ll need to update the networking config. Where eth1 should be replaced with the modem’s device name. From the command line, enter: sudo route add default gw 192.168.1.1 eth1 If you get an error, you may need to add a route configuration so that network traffic is routed to the new cellular interface. Set up the Hologram APN profile and connection settings as described in the Windows/Mac instructions above, then click the Connect button on the device home page.Disable or unplug your PC’s other network connections (ethernet or wireless), then test your internet connection: ping -c1 hologram.io
Where eth1 should be replaced with the modem’s device name.Open a web browser to 192.168.1.1 to configure the modem via web UI. If the network interface doesn’t have an IP address assigned (no inet addr entry in ifconfig ), run the DHCP client to acquire an address: sudo dhclient eth1
0 kommentar(er)
